This is a Kit specific to F82 / F32 M4 and 4 Series BMW vehicles
This kit can be powered using the wiring on the 12V cigarette lighter outlet under the pasenger side front seat.
Step 1: power the main controller using the 12v positive and ground connection on the cigarette lighter wiring under the front passenger side seat. You will need an 8MM socket to remove the panel under the dash to access it.
Step 2: Install the dash strips by carefully removing the carbon fiber insert and using VHB 5952 1/4″ 3M double sided tape to attach the strips (you will need about 15 feet). Lights in your desired area by pushing them securely into any gap or split in your interior. You may need a squeegee or credit card to help fit the lights in tight areas. It is important to note that lights only bend one way, so be sure to test and keep this in mind when installing. Run wires as well and as cleanly as possible for the best results. Wires can be tucked into cracks and crevices as needed.
Step 3. Each strip is cuttable as needed for best fitment. It can be cut using common household scissors. The strips can be cut after or before any led. If you cut on a led and experience flickering, cut a little more off, and the lights should function as normal. Do not cut off the wire end. Please cut the end away from the wire.
Step 4: Power each strip directly to the wiring harness using the included extension wire and hide wires as best you can.
Step 5: Make sure Bluetooth is enabled on your phone. Then open the app Magic Car Light to control your lights and enjoy!